BACTERIA IN PURIFIED WATER

Bacteria able to form Colony Forming Units

These living microorganisms are capable of growing in 18 megohm.cm waters. Bacteria are a common cause of problems associated with high purity water systems. Regular testing enables the detection of rising levels before they are able to cause product loss. The most influential criteria for the presence of bacteria, in a water system, are low flow rates.

Epifluorescent (TOTAL) bacteria cell counts

This method yields results in terms of total (living and dead) bacterial cells present in 100ml of sample. Epifluorescent bacteria counts are most often used in conjunction with viable counts. Rising total cell counts are a good indication of slime becoming dislodged, or other issues that put an increased load on the water purification system.

LAL (Limulus Amoebocyte Lysate) or Pyrogen Test for Endotoxin levels

This “endotoxin” assay quantifies the gelatinous, polysaccharide matrix that surrounds gram negative bacteria (most bacteria in the ultrapure water system). Since there is no average amount of polysaccharide associated with a cell, the test results are given as nanograms per milliliter of water.

CONTAMINANT

Bacteria

PROBLEM

High port counts

 

High at pt.of use

High tank counts

CAUSE

Dead Leg
Bad port

low flow
dead legs
tank too large

POSSIBLE CURE

Shorten leg,
Increase flush time until ok
Replace port

Bigger pump
Reduce back pressure

Smaller tank
Higher flow rates
Nitrogen blanket
Ozone layer